LCKS74M NV assault rifle replica (ASCU version)

Description

Replica of the LCKS74M NV carabiner (ASCU version)

Replica of the most famous product of Soviet technical thought - an assault rifle designed by Mikhail Kalashnikov, in a modified version.

The replica was made from the highest quality components, with great attention to detail and reproduction of the original. Almost the entire replica, apart from a few small parts, is made of steel. The exception here is, of course, the pistol grip made of plastic and the front bed including the gas tube cover.

The replica is characterised by high durability due to the materials used and the quality of workmanship. There are no signs of loosening or inaccuracies in the workmanship and accuracy of fit of the components. The entire structure looks like a single, solid component. The internal parts, in turn, enable simple tuning and ensure long and trouble-free operation in the basic configuration.

The guaranteed initial firing speed of ~415 FPS makes this rifle an ideal choice for any Stormtrooper. At the same time, the durability and build quality ensure that the replica can be used not only for standard shooters, but also as a mock or simulation replica. The mounting of optics is made possible by a lateral mounting rail of the "dovetail" type, which is located on the left side of the housing.

The carbine has a frame plunger that is folded into the side of the housing, making it much easier to transport and store the replica, as well as to use it in confined spaces during CQB games. The reduced length of the design also plays an important role here.

The replica is supplied with a polymer hi-cap magazine with a capacity of 500 rounds.

The kit does not include a battery or charger.

The kit contains:

- Replica
- Magazine

The replica has a ASCU 3+ chip, which is built into our service.

ASCU is a two-part electronic module (control unit and sensor unit) which, when installed in airsoft replicas, can be used to control the airsoft system, significantly improved their performance. The traditional contact system has been replaced by a sensor unit that monitors the current position of the piston pinion, the fire selector switch and the trigger. The collected information is forwarded to the control unit - where software in the processor analyses it and controls the motor of the replica with an active MOSFET brake.

Version 3+ is above all:

- Polymer covers on the circuit boards to prevent damage, e.g. during installation.
- Improved replica culture in semi-auto mode
- Prevents accidental double shots - each trigger pull is 1 shot
- New fire interruption lever and selector plate especially for the ASCU
- New lower-resistance, more flexible cables
- No reworking necessary on reinforced gearboxes

ASCU improves gearbox v.3 and makes the replica equivalent to the most expensive and sophisticated replicas of the PTW class.

The ASCU system monitors the operation of the replica independently of the speed of the trigger and is responsible for the complete execution of the piston cycle, both in semi-automatic and continuous fire mode. After each shot, the piston stops in the starting position.

ASCU has a Low Drain Protection-system, which was specially developed to prevent damage to the lithium polymer batteries (LiPo).

ASCU interrupts the firing mode of the replica in the event of problems and thus protects the internal components from further damage.

Full description below:

http://gunfire.pl/product-pol-1152202709-ASCU-Gen-3-do-GearBox-v-3.html