CM040J assault rifle replica (ASCU version)

Description

CM040J assault rifle replica (ASCU version)

A new line has been added to the family of CM replicas based on the popular Russian assault rifles - modified with a range of 'tactical' accessories, Increased ergonomics and possibilities of Configuration of this classic design.

The replica was Perfectly coordinatedthere are no setbacks here, the product was carefully developed in matt, black colour processed. Steel, aluminiumZn and aluminium alloys and polymers were used in the construction. The receiver, the folding stock, the dust cover, the trigger guard and the fire selector switch were made of steel manufactured. The gas pipe and the RIS rail were made from Aluminium while the front and pistol grips are made of plastic.

The replica has a laterally bevelled frame shaft. On the gas tube there is a 22mm RIS mounting railwhich allows the rifle to be fitted with additional accessories. In addition, on the left side of the housing the AK side rail This enables the mounting of special telescopic sights or additional RIS rails. The fire selector characteristic of the AK is located on the right-hand side

Disassembly of the replica and assembly of additional accessories is made easier by the pin and lever-based design itself similar to the real steel and other AK replicas in the popular VFC standard. The outer barrel ends with a 14mm right-hand threadwhere the flash hider was mounted. The battery of the replica is located under the dust cover (included in the set).

The replica is made by a very reliable and easy to upgrade Gearbox v.3 with reinforced frame powered. Inside, a set of Steel gear racks, 7mm steel plain bearings, a reinforced pistons and spring slides. Efficiency is maximised by a 455mm long inner track and a dense Metal hop-up chamber guaranteed.

The replica is supplied with a plastic high-cap magazine with a capacity of 500 BBs

The ASCU is a two-part electronic module (the control module and the sensor module) which, once installed in the airsoft replicas, significantly improves their functionality. The traditional hinge module has been replaced by a sensor module that monitors the current position of the piston thread wheel, the firing mode selector lever and the trigger. The information collected is sent to the control module, where the software in the processor analyses it and controls the replica's motor using the active MOSFET brake.

ASCU Gen. 3+ includes the following upgrades:

- Additional polymer padding of the circuit boards to protect them from damage during installation
- Outdated short-circuit software removed, making shots in semi-automatic mode much faster
- each pull of the trigger leads to a single shot, the new system prevents double shots
- New switch-off lever and selector disc specially developed for the ASCU
- New, thicker wires
<span style="colour:

The ASCU improves the operation of a V.3 gearbox and ensures that the replica is on a par with the more expensive replicas and the more sophisticated PTW-class replicas. The ASCU system monitors the operation of the replica regardless of the speed at which the trigger is pulled and is responsible for the entire cycle of piston operation, both in semi-automatic and fully automatic firing modes. The piston stops in the home position after each shot.

The ASCU is equipped with the Low Drain Protection System, which was specially developed to protect the lithium polymer (LiPo) batteries from damage.

In the event of an emergency, the ASCU stops the fire mode in the replica and thus protects the internal elements from further damage.

The ASCU is easy to install in the replica, which is equipped with the V.3 gearbox. For most models, no changes to the original parts of the airsoft rifle are required. In some cases, however, some minor modifications will need to be made - thanks to these, the installation process will be completed without any problems.

The set includes:

- Replica
- Magazine
- Battery
- Charger