WARFET v1.1 MOSFET circuit

WARFET MOSFET module with programming device

WARFET is a MOSFET module of the latest generation designed for use in AEG replicas. It is the most advanced electronic module on the market and at the same time the easiest to use and, above all, to programme. The use of the latest technological solutions in MOSFET production made it possible to design a small but very advanced and durable module. The installation of the controller does not require any intervention in the interior of the replica - it is limited to connecting the module between the battery and the terminals of the replica. REQUIRES NO SOLDERING!

Programming card (not included) enables the module to be programmed at any time, in any situation and under any conditions. Both the module and the card have the MIL-V-173C military standard certificate for weather resistance. This means that the user can be sure that this advanced module will never fail. The entire set has also been made compatible with Li-Po batteries. It works with batteries with a voltage of 7.4V to 14.8V. Built-in protection devices protect the Li-Po battery from over-discharge, which could damage it.

The module allows the Programming the following options:

– Pretensioning - After each shot, the spring is loaded to shorten the time between a shot and the trigger being pulled. The strength of this option can be adjusted via the Pretensioning can be programmed in such a way that it limits the utilisation of a gearbox or reduces the reaction time even further - by forcing an increased load and utilisation of parts.

– Active brake - Function of the active brake. Reduces parts utilisation by preventing spring overload after each shot. This option will be much loved by power-tuned replicas. For use with half-fire. Full auto fire with this option will cause blank shots.

– Smart Trigger - this option should be used with burst fire, it allows you to reduce the rate of fire of the shots in burst mode. The rate of fire is set via the ROF CONTROL controlled.

– Dark mode - switches off the controller LED, which is switched on when a trigger is pressed.

– Burst time - This option allows you to programme the length of a burst, which influences the number of shots in a burst.

- The last option allows you to define the settings for the fire mode selector. The module can work with advanced fire mode selectors with one- and two-wire triggering mechanisms. The settings for the series wiring have two options available: SEMI/AUTO, SEMI/BURST. However, three options are available with modified cabling: SEMI/AUTO, SEMI/BURST, BURST/AUTO.

A detailed description of all functions can be found on the manufacturer's website: http://www.gatee.eu

Detailed manual is available at the following address:

http://gatee.eu/images/gate/instrukcje/WARFET-EN.pdf

The set contains:

- WARFET module

- Battery AEG Tamiya small adapter

- AEG battery Tamiya small adapter

- Pair of Deans T-plugs

- single trigger cable

- Double release cable