MOSFET module V3 with wiring

MOSFET module V3 with cabling

This MOSFET unit is intended for use in electrical replicas with GB V3. The
MOSFET module is installed in a switch assembly from SHS. Compatible with
Ni-MH 8.4 - 12 V and Li-Po 7.4 - 14.8 V. It is possible to connect it with 1.5 mm
Wiring. The use of a MOSFET module increases the firing rate of a replica,
prevents switch assemblies from burning out and protects the contacts. The device
consumes no power when idle and also prevents sparking when connected
a battery to the device. The device is coated with a special varnish that protects it from moisture and water.
protects against moisture and water.

This model is designed for use with M130 springs and a maximum rate of fire of
25 BBs / second. It can also be used with the following springs
M160 springs can be used under the condition of longer time intervals between shots. 

The set contains:

- MOSFET unit
- Wiring
- Plug connector
- Shrink tubing
- Security